Get Started - Silk’n Lipo H5001 Manual Del Usuario

Headache
Equally rare, is the possibility that you might feel light-headed when you start using
the device. If this happens, sit down during the treatment, or stop using the device
until you feel OK.
EN
Allergic reaction
If you have an allergic reaction to the device or its accessories, stop using the device.
a
Stop use immediately if any of these effects are more severe.
a
See your doctor if the effects do not go away within 2 to 3 days.
7.

Get started!

Treating with Silk'n Lipo is easy. Just follow these steps for each part of the body
you wish to treat.
1. Use on clean, healthy skin (see section "1. Warnings & contraindications").
Check that the batteries are well charged before use. If the battery/error
2.
light is orange and blinks slowly, this indicates that the battery is low.
Before each treatment, wet the electrode pad with a wet cloth or with
3.
wet fingers, and place them on each treatment unit (see section "4.4
Wetting the electrode pads"). Next, connect one or more treatment units
to the belt (see section "4. 1 Connecting the different parts").
Disconnect one of the connectors on one side, and then place the
4.
belt around the area you wish to treat. Then reconnect the side you just
disconnected.
Adjust the tightness of the belt so that the treatment unit is in good
5.
contact with your skin, and that the belt is firm and well secured to
your body.
If the belt is not tight against your skin, the EMS energy may disconnect. If
a
that happens, tighten the belt and press the + button to reselect the EMS
energy level required.
Switch on. With the controls in view, press the control button on each
6.
treatment unit. The green and orange indicator lights will go on. The
orange indicator light will go off after a second or so and the treatment
unit will vibrate once. When the treatment unit is in good contact with
the skin, the green operating light will blink slowly, and the laser energy
will start to work.
16