- Push the pneumatic control lever up (Fig.
27) to lift the bead over the demounting
head.
- Press the turntable drive pedal, making
the wheel turn clockwise. The upper bead
will be automatically guided up and over
the rim edge (Fig.28).
- Lift the second bead manually over the
head (Fig. 29), then turn the turntable
clockwise until the tyre has been com-
pletely demounted from the rim.
- Tilt the column backwards.
Operator's manual A 2025 LL
NOTE: When working with wide wheels
(13" - 14"), the SP2000 disc must be used
to lift the second bead onto the mount-
ing/demounting tool (Fig. 30).
WARNING
Always check that the tyre size is compa-
tible with the rim size before mounting.
- Ensure that the tyre is in good condi-
tion and undamaged, then lubricate
the beads (see chapter relative to soft-
28
walled tyres).
- Place the tyre over the wheel and tilt the
tower forward.
- Mount the lower bead, proceeding as
described for soft-walled tyres.
Proceed as follows to mount the upper
bead:
- Use the SP2000 disc to create a large
enough gap to first insert the edge guard
and then fit the clamp onto the edge
guard itself (see Fig. 31).
29
30
Mounting
UK
53