Wheel Mounting - Corghi A 2030 Manual De Uso

If the tyre has an inner tube, after demounting the upper bead, tilt the column back
and remove the inner tube before proceeding to demount the lower bead.
Turntable rotation can be stopped at any moment by releasing the drive pedal.
To rotate in the opposite direction, simply raise up the pedal.

8.6. WHEEL MOUNTING

RISK OF EXPLOSION. Always check that the tyre/rim combination is correct in terms
of compatibility (tubeless tyre on tubeless rim, tyre type with inner tube on rim for
inner tube) and geometric dimension (shrinkage diameter, width cross section,
off-set and shoulder profile) before mounting.
AVOID THE RISK OF PERSONAL INJURIES OR DEATH.
Also check that the rims are not deformed, that their fastening holes have not
become oval, that they are not encrusted or rusted and that they have no sharp
burrs on the valve holes.
Check that the tyre is in good condition with no signs of damage.
- Before you start with tyre mounting
operations, lubricate the beads (fig.27).
Lubricated beads require less force to
mount and are protected against damage.
- Check that the tyre is in good condition
with no signs of damage.
- Place the tyre on the rim and tilt the pole
into the working position
the lower bead (fig.28) beneath the right
hand side of the tool head.
Press the turntable control pedal
to turn the bead clockwise and mount it. Use the rim channel by pressing on the right
wall of the tyre to reduce traction force on the bead as the wheel rotates (fig.28).
A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator's manual
CAUTION
DANGER
. Position
27
EN
113