Measuring Blood Pressure - Beurer BC 28 Instrucciones De Uso

• Select the desired year using the memory button M and
confirm with the START/STOP button
The month flashes on the display.
• Select the desired month with the memory
button M and confirm with the START/STOP
button .
The day flashes on the display.
• Select the desired day with the memory button
M and confirm with the START/STOP button
If the hour format is set as 12h, the day/month
display sequence is reversed.
Time
The hours flash on the display.
• Select the desired hour using the memory
button M and confirm with the START/
STOP button .
The minutes flash on the display.
• Select the desired minute using the mem-
ory button M and confirm with the START/
STOP button .
Once all the data has been set, the device switches off
automatically.

5. Measuring blood pressure

.
Attach the cuff
Blood pressure may vary between the right and left arm,
which may mean that the measured blood pressure val-
ues are different. Always perform the measurement on
the same arm.
If the values between the two arms are significantly dif-
ferent, please consult your doctor to determine which
. arm should be used for the measurement.
1
• Expose your left wrist. Ensure that the circulation of
the arm is not hindered by tight clothing or similar.
Place the cuff on the inside of your wrist.
• Close the cuff with the hook-and-loop fastener so that
the upper edge of the device is positioned approx. 1
cm underneath the heel of the hand.
• The cuff must be fitted tightly around the wrist, but
must not constrict.
23
2 3