Fuel System Selection; Initial Start-Up (No Load); Installation Inspection - Briggs & Stratton Standby Manual De Instalación, Arranque Y Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FUEL SYSTEM SELECTION

The engine of your Home Standby Generator is factory
calibrated to run on natural gas (NG). It may also be
operated on liquid propane (LP).
To configure the fuel system for LP use:
1.
LP fuel inlet pressure must be between 11 and
14 inches water column.
2.
Pull service disconnect from disconnect box.
3.
Remove 15 Amp fuse from control panel.
4.
Change main jet in fuel mixer following instruction
sheet provided in LP conversion kit.
5.
Reinstall 15 Amp fuse in control panel.
6.
Reinstall service disconnect in disconnect box.
The generator is now ready to operate using LP fuel.With
a fixed main jet for LP gas, there is no need to perform any
engine adjustments for LP operation.
INITIAL START -UP
Begin testing the generator without any electrical loads
connected, as follows:
1.
Set generator's main circuit breaker to OFF (open)
position.
2.
Install 15 Amp fuse in control panel.
3.
Push and hold START/RUN/STOP switch in START
position until LED comes on.
IMPORTANT: If you release the switch from the START
position before LED comes on, the generator will shut
down.
NOTE: DO NOT crank engine for more than 15 seconds,
then pause for 15 seconds to reduce heat in starter. Repeat
process until engine starts.
More user manuals on
Briggs & Stratton Power Products Home Standby Generator
Installation, Start-Up and Owner's Manual
(NO LOAD)
ManualsBase.com
NOTE: When the Home Standby Generator is started for
the very first time, it will require that air in the gaseous fuel
lines be purged.This may take a few minutes.
4.
Listen for unusual noises, vibration or other indications
of abnormal operation. Check for oil leaks while the
engine runs.
5.
Let engine warm up for about five minutes to allow
internal temperatures to stabilize.Then, set generators
main circuit breaker to ON (or closed) position.
6.
Connect an RMS AC voltmeter and a frequency meter
to check generator output at load side of circuit
breaker.Voltage should be 230-240 Volts, frequency
should be 62.0 - 62.5 Hz.
7.
Check generator output between one generator
connection lug and neutral lug, then between other
generator connection lug and neutral lug. In both cases,
voltage reading should be between 115-120 Volts.
8.
Push and hold START/RUN/STOP switch in STOP
position until LED turns off. Engine will shut down.
INSTALLATION
INSPECTION
Before placing the Home Standby Generator into service,
inspect the entire installation carefully. Ensure that any
scratches or broken paint on the inside or outside of the
enclosure are touched up with the supplied paint.
Complete the "Installation Checklist" as you make the
inspection. Ensure all items have been filled-in and all
signatures have been obtained. Instruct the owner to mail
the white copy to:
Briggs & Stratton Power Products
Warranty Registration
P. O. Box 1144
Milwaukee,WI 53201-1144
18

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

195362gs700001975-0

Tabla de contenido