bora PL 540 Manual De Instrucciones página 18

Installation of the cooker extractor
First decide which side you want the air vent to be on.
The BORA extractor unit is generally delivered with the
air vent towards the right as shown in Fig. 3.
In order to have the air vent projecting to the left, do
the following:
1. Loosen the 5 screws on the bottom of the
cooker extractor unit
2. Remove the air vent and turn it 180° towards
the left (see Fig. 4)
3. Reconnect the vent to the upper frame of the
extractor unit and tighten the screws
4. Make sure that there is no air gap between
frame and vent as this can reduce the
performance of the extractor unit
Now fit the extractor unit into the designated opening in
the countertop.
Tensioningscrew
Then position the mounting rails (which are delivered
with the cooktop) to the left and right of the cooktop.
.
Then position the mounting rails (which are delivered
with the cooktop) to the left and right of the cooktop.
For flush mounting:
Achieve exact levelness by balancing any
height differences through the addition or
removal of materials.
Position the cooker extractor so it is exactly in the
centre. Rotate the brackets under the countertop.
Fixate the position of the extractor by tightening the
four tensioning screws. Do not overtighten the screws.
After tightening the screws, check the correct position
of the cooker extractor.
The next step is to establish the air outlet connection,
as shown in Fig. 3 on page 8. Use the specified
COMPAIR Flow 150 system by Naber for the outlet
duct.
18
GB
Bracket