Omer Air XII Manual De Instrucciones página 3

WARNING: Do not, for any reason whatsoever, modify or replace any com-
ponent of the gun. The assembly or disassembly of any part must be perfor-
med exclusively by authorized dealers.
WARNING: Airbalete is a high-precision product that requires a considerable
amount of care and regular maintenance, to be performed exclusively by
authorized dealers, at least once a year.
WARNING: When loading the shaft, be sure that the piston is securely atta-
ched to the triggering mechanism before releasing the shaft!
WARNING: For your safety and the safety of others, and to avoid damaging
the gun, NEVER load or SHOOT the gun outside of the water!
WARNING: Do not aim the weapon at others, even if the safety is engaged.
WARNING: Before shooting be certain that the shaft is inserted. In the event
that the shaft should accidentally fall out (which could be caused by a worn
shank that does not secure the piston properly) do not shoot since the weight
of the shaft could damage the piston and the shock-absorber bushing; in this
case reinsert the shaft and shoot as you normally would.
WARNING: At the end of use, discharge the airgun in the water before co-
ming out.
WARNING: Avoid prolonged exposure to the sun or heat sources.
WARNING: Do not insert the shaft if the muzzle has come in contact with
the sand to avoid causing permanent damage to the barrel and the piston.
WARNING: Rinse the gun with fresh water after each use.
WARNING: Only use the pump when the pressure is not suffi cient, and not
with each use. Looking through the side holes, check to be sure that the
piston is positioned at the end of the shaft and not attached to the sear. Be
sure that the pump's threading is clean and in good condition. Refer to the
table listing the number of pre-charge pump strokes to obtain the desired
pressure while keeping in mind that the pressure levels refer to guns that are
completely discharged.
WARNING: When transporting the gun by air, the gun must be discharged
ahead of time to a maximum internal pressure level of 10Atm/145PSI.
WARNING: If you believe that the trigger sensitivity needs to be regulated,
follow the instructions listed in this manual. However, the shaft must NOT
be inserted, since it could be released while regulating the gun mechanism.
WARNING: If the shaft should accidentally be released, but without the
shank (since the shank could be unhooked from the piston), be sure to
completely discharge the weapon by removing the air from the gun before
removing the piston. Remove the shank from the piston.