Switching Off - AUtec Modular Serie Manual De Usuario

SWITCHING OFF

The transmitting unit should be
switched off each time work is
stopped by turning the starting key
to "O" and extracting it (always put
the key in a safe place).
The unit may also switch off if the bat-
tery is not sufficiently charged and/or
when the radio remote control is not
used for more than 3 and half minutes
(refer to paragraph 8 "Programming"
DIP nr. 1 settings.).
BATTERY
To recharge a flat battery, proceed as fol-
lows:
1. Insert the battery into its proper battery
charger, which should be positioned in an
area having a temperature of between
+5°C and +45°C. The battery now starts
charging, a state signalled by the lighting
up of the "CHARGE" pilot light.
2. After a maximum of 3 hours the
"CHARGE" indicator switches off: the bat-
tery is fully charged. Remove the battery
from the charger (if the battery is not re-
moved, charging continues in mainte-
nance mode).
Page 24 of 71
!
To stop the machine immediately,
press the STOP button.
To start working again, after having
made sure that the working conditions
are safe, turn the STOP button in the
direction indicated to deactivate it and
repeat the starting procedure.
6 - MJ transmitting unit operation
STOP
The STOP button should
be used when it is nec-
essary to stop the ma-
chine immediately in
order to check any dan-
ger condition.
LIMJNMU0