Start Sequence - Ottobock E-MAG Control Instrucciones De Uso

Putting into operation
First plug the battery charger into a power outlet and then insert the battery into the charger.
One full charging cycle takes between 8 to 10 hours.
In daily use, the charging time depends on the remaining capacity and maintenance of the
battery.
TIP!
The charger can charge two batteries at the same time.
Place the charged battery into its receptacle; it should snap easily into the holder (Fig. 3).
Once the battery is connected to the system, the E-MAG Control is activated and the start
sequence launched. Please also read the following section 4.2 Start sequence.

4.2 Start sequence

CAUTION!
Risk of Falling
Missing signals during the start sequence indicate a failure of the E-MAG Control.
Be attentive to all signals listed here.
Every time the E-MAG Control is activated, the electronic control unit runs a short self-test that
emits the following signals:
Signal
Status
System
ready
Signal table 1: Launched start sequence
After successful completion of the start sequence, the electronics will indicate the current status
of the lock with a set of light, sound or vibration signals, or a combination of these signals.
The current lock status is indicated with either one of two available response profiles, i.e. sets
of signals. You can select your preferred profile (Blue or Purple) and switch back and forth
24 | Ottobock
Light
1 x deep / 1 x high (long)
Blue
Red
White
Sound Vibration
long
E-MAG Control