Installing Your Refrigerator; Unpacking Your Refrigerator; Installation - LG LRBP1031T Instrucciones De Uso

Frigorifico-congelador
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING YOUR
REFRIGERATOR
w w WARNING
Excessive Weight Hazard
Use two or more people to move and
install refrigerator.
Failure to do so can result in back or
other injury.

Unpacking Your Refrigerator

Remove tape and any temporary labels from
your refrigerator before using. Do not remove
any warning type labels, the model and serial
number label, or the Tech Sheet that is
attached to back wall of the refrigerator.
To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue residue
can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your refrigerator. For more
information, see Important Safety Instructions
in the Refrigerator Safety section.
Refrigerator shelves are installed in the
shipping position.
Please reinstall shelves according to your
individual storage needs.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the
refrigerator for cleaning or service, be sure
to protect the floor.
Always pull the refrigerator straight out when
moving it.
Do not wiggle or walk the refrigerator when
trying to move it, as floor damage could occur.
4
w w WARNING
Explosion Hazard
Keep flammable materials and vapors,
such as gasoline, away from refrigerator.
Failure to do so can result in death,
explosion, or fire.

Installation

1. Avoid placing the unit near heat sources,
direct sunlight, or moisture.
2. To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to
compensate for uneven floor.
The front should be slightly higher than the
rear to aid in door closing.
Leveling screws can be turned easily by
tipping the cabinet slightly.
Turn the leveling screws clockwise (
raise the unit, counterclockwise (
lower it.
3. Install this appliance between 55 °F (13 °C)
and 110 °F (43 °C.) If the temperature
around the appliance is too low or high,
cooling ability may lessen.
NEXT
1. Clean your refrigerator thoroughly and wipe
off all dust accumulated during shipping.
2. Install accessories such as ice cube bin,
drawers, shelves, etc., in their proper places.
They are packed together to prevent possible
damage during shipment.
3. Let your refrigerator run for 2 or 3 hours
before putting food in it.
Check the flow of cold air in the freezer
compartment to ensure proper cooling.
Your refrigerator is now ready for use.
) to
) to

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lrbp1031wLrbp1031ni

Tabla de contenido