Refrigerator Installation; Unpacking Your Refrigerator; Installation; Base Grille Installation - LG LSXS22423 Manual De Usuario

Ocultar thumbs Ver también para LSXS22423:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move and install the
refrigerator. Failure to do so can result in back or other
injury.

UNPACKING YOUR REFRIGERATOR

Remove tape and any temporary labels from your
refrigerator before using. Do not remove any warning
type labels, the model and serial number label.
To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can also be
easily removed by rubbing a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol,
flammable fluids or abrasive cleaners to remove tape or
glue. These products can damage the surface of your
refrigerator. For more information, see the Important
Safety Instructions section.
Refrigerator shelves are installed in the shipping
position. Please reinstall shelves according to your
individual storage needs.
WARNING
WHEN MOVING YOUR REFRIGERATOR
Your refrigerator is heavy. When moving the
refrigerator for cleaning or service, be sure to protect
the floor. Always pull the refrigerator straight out when
moving it. Do not wiggle or walk the refrigerator when
trying to move it, as floor damage could occur.
WARNING
EXPLOSION HAZARD
Keep flammable materials and vapors, such as
gasoline, away from refrigerator. Failure to do so can
result in death, explosion or fire.

INSTALLATION

1. Avoid placing unit near heat sources, direct sunlight or
moisture.
2. To minimize noise and vibration, the refrigerator
MUST be installed on a solidly constructed floor.
3. Carpeting and soft tile surfaces are not
recommended.
4. NEVER install the refrigerator on a platform or a
weakly supported structure.
5. Install this appliance in an area where the
temperature is between 41°F (5°C) and 110°F (43°C).
If the temperature around the appliance is too low or
high, cooling ability may be adversely affected.

REFRIGERATOR INSTALLATION

NOTE: For proper air circulation, and best
• Be careful when you work with the hinge, base
grille, stopper, etc. You may be injured.
• Do not put hands or metal sticks into air vents,
base grille or bottom of the refrigerator. You may be
injured or receive an electrical shock.

BASE GRILLE INSTALLATION

To remove the base grille:
1. Open the doors (refrigerator and freezer).
2. Once doors are open, remove screws from base grille.
To install or replace base grille:
1. Place base grille into position and insert and tighten

HANDLE REMOVAL

You may have to remove the door handles to move the
refrigerator through a narrow opening. See instructions
below.
NOTE: To avoid damaging door surfaces when moving
•Loosen the set screws with a 3/32" (2,38 mm) Allen
wrench and remove the handle.
NOTE: If the handle
8
cooling and energy consumption
results, maintain a minimum
distance of 2 inches (5,08cm) from
adjacent items and surfaces.
WARNING
Remove base grille and set safely aside.
screws.
the refrigerator through narrow openings, it is
ALWAYS recommended to remove the doors as
instructed in the next two pages.
Mounting
mounting
fasteners
fasteners need
to be tightened
or removed use
a 1/4" (6,35
mm) Allen
wrench.
2" (5.08 cm)
Set screw
Allen Wrench

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mfl62884312

Tabla de contenido