Technical Specification - BOJ FP-3500X Manual De Uso

English
Tips and warning:
The ratio of flour to water while doughing is 1:0.6, means 100 g flour need 60 g water to make
best effect; The standard of processing time is within 30 sec, that's because the flour will become
sticky and stick to the blade adapter if the time lasts too long. Then it will make the machine
shake, and work abnormally.
Disc for shredding, slicing and French fry cutting disc (11-15)
Standard processing time is 1 minute.
Choose the blade disc according to ingredients and the shape you want. Put the blade disc you
choose into the plastic disc holder (5), then seat it in the driving shaft (4), close the processing
bowl cover (7), and lock it well. You can start to process the food when the machines work
normally.
DO NOT be violent while pushing the ingredients in feed chute by pusher. It's better to chop large
shape ingredient into smaller one to fit the feed chute size.
Lower speed is recommended while slicing soft ingredient to prevent it from pasty.

Technical specification

Model: FP-3500X
Voltage: 220-240V~50HZ
Rated power: 1000W
Processing bowl capacity: 3.5L
Installation and maintenance
Installation:
1. Position the motor base (2) on the flat and dry board.
2. Position the processing bowl (3) onto motor base, turn clockwise to make it fixed firmly.
3. Place driving shaft (4) onto the rotor inside the bowl, seat it vertically.
4. Open the blade box (8) of motor base and take the blade you want. For example, when using
the chopping blade (10) or dough blade (9), just seat it in driving shaft (4); When using slicing,
shredding or French Fry cutting baldes, please fix it on blade disc (5) first, then seat the blade
disc (5) in driving shaft (4).
Attention: only one blade can be used every time.
5. Put the food into the processing bowl (3) and then close the bowl cover (6) while using the
chopping blade (10) or doughing blade (9). When using slicing, shredding or French Fry cutting
blades, make sure to lock the bowl cover (6) first, ingredient should be filled through feed chute
after the machine is ready.
6. Lock the bowl cover (6), the safety lock is active now.
7. Be attention: the switch should in the "0" speed; connect the plug with socket, using pulse
function to confirm whether the machine is assembled well. If there is anything abnormal,
unplug the machine and re-assemble it as above.
- 4 -