Amate Audio Xamp3K Manual De Usuario página 7

Xamp3K
AC 220/240V – 50/60Hz
Average current draw: 3 A Musical Program
WARNING: the connection to any other voltage different from the one
specified can damage the amplifier immediately.
4.2 Connection of the loudspeakers
The loudspeaker system should be connected to the Speakon or binding posts
connectors ensuring that the polarity is correct. It is very important to use a cable
fitting to the power of the amplifier in order to maintain the high damping factor these
units provide.
As a general guideline, we offer a table showing the recommended cable section for
different cable length, in order to keep power and damping factor loss in acceptable
values.
Cable Section
2.5mm
2
4mm
2
6mm
2
8 mm
Table 1. Maximum recommended cable length
The following speaker outputs are available:
Fig. 4. Available loudspeaker connectors on the rear panel
Speakon sockets: Each pole can fit a maximum wire section of 4mm
• OUT Speakon: Loudspeaker output connection for both channels. The
Speakon connector (not included) has 4 terminal poles labelled as +1(+LOW),
-1(-LOW), +2 (+HIGH), and -2(-HIGH).
• LINK Speakon: This connector is connected in parallel with the Speakon
OUT.
7
5 A Heavy Duty
Max. recommended cable length
8 Ohm Load
2
(AWG14)
(AWG12)
(AWG10)
(AWG 8)
4 Ohm Load
20 m
30 m
40 m
50 m
May 2016
10 m
15 m
20 m
25 m
2
(12AWG).
Amate Audio