Electrical Connection - Faber VEIL Manual De Instrucciones

Fitting the Chimney
Lift the 2 tabs formed on the Hood Canopy close to the
air outlet opening.
Upper chimney
• Open the two side pieces out slightly, hook them up
behind the brackets 7.2.1 and bring them back
together again until they are in contact.
• Fix them to the sides of the Brackets using 4 Screws
12c (2.9 x 9.5), provided.
Lower chimney
• Open out the two Chimney side flaps, hook them up
between the upper chimney and the wall and then
close them up again until they touch.
• Fix the lower part to the Hood canopy tabs at the
sides, using 2 screws 12c (2.9 x 9.5) provided.

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole
switch having a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Mainte-
nance) being sure that the connector of the feeding
cable is correctly inserted in the socket placed on the
side of the fan.
EN
2
20