Complete The Installation - Dyson Airblade 1A Instrucciones De Instalación Y Manual De Mantenimiento

Fig. 3
For side cable entry
installation
Using suitable fixings (not countersunk
screws), fix the backplate to the wall.
Identify which side the cable will enter.
Unscrew the entry tab on the machine.
Cut the rubber side tab of the conduit box
on the side that will be facing downwards
after installaton.
Use a suitable cable gland/conduit connector
(not supplied) for the installation.
Secure the conduit box on the wall using
suitable fixings.
Unscrew and remove the cable clamp,
terminal block and terminal block holder
from the backplate. Loosen all three screws
on the terminal block, ensuring the pre-
installed earth wire remains in place.
Cut the gland smaller than the diameter of
the cable and feed the cable through the
conduit box and gland. Don't remove the
gland from the backplate.
Make sure that the cable sits securely in the
cable guide. Any part of the cable not seated
securely may prevent the machine from being
fixed properly onto the backplate.
Secure the live, neutral and earth wires to
the appropriate terminal block locations, as
indicated on the backplate. Ensure the pre-
installed earth wire remains securely inserted
into the connector block.
Secure the terminal block to the backplate
with the terminal block holder and secure the
cable clamp.
Only clamp double insulated cables with the
cable clamp.
Don't overtighten any of the electrical fixtures.
Fig. 4
Install the main body
This Dyson Airblade™ hand dryer has
two power modes, 900W and 650W.
The machine is set to 900W as default. If
required, change the power mode to 650W
before installation.
Hook the machine on to the backplate and
gently lower the bottom of the machine
until it is flush with the wall. Check that both
backplate hooks are securely in position
before continuing.
Fix the 2 security screws into the bottom of the
machine using the tool supplied.
Fig. 5

Complete the installation

Place the filter unit in the machine and make
sure it clicks securely into place. Turn on the
mains power supply and test the machine is
working as it should by placing hands in sight
of the sensors.
Please hand this manual to the
owner/facilities manager.
29