RIDGID R4031 Manual Del Operador página 16

ASSEMBLY
INSTALLING THE MITER GUIDE
See Figure 13.
The miter guide can be used from both the left and right side
of the cutting wheel.
 Place the slot on the underside of the miter guide on the
sliding table fence.
 Lock the miter guide securely to the table by turning the
lock knob clockwise.
To adjust angles:
 Loosen the miter knob.
 Rotate to the desired angle by moving the guide left or right.
 Tighten the knob securely before turning on the saw.
INSTALLING THE WATER PUMP
See Figures 14 - 15.
The pump recirculates water from the tray to the cutting
wheel.
 The pump is equipped with suction feet to secure in place.
Press down firmly on the pump to attach the feet to the
bottom of the water tray.
 Check to make sure the water pump's electrical cord and
water hose have been placed under the frame rails and
over the left side of the frame as shown in figure 15.
 Push the end of the 90° fitting into the hole on top of the
water pump.
MITER
KNOB
45
SLOT
CLEAR
HOSE
WATER
PUMP
MITER
GUIDE
LOCK
KNOB
Fig. 13
90°
FITTING
Fig. 14
16 — English
 Connect the clear hose to the barbed end of the 90°
fitting.
 Position the pump as shown in figure 14, with the hose
end of the fitting facing the rear of the tray.
 Plug the pump's electrical cord into the receptacle in the
rubber boot on the electrical cord.
FILLING/CHANGING THE WATER RESERVOIR
See Figures 16 - 17.
 Fill the water reservoir with clean tap water to the fill line.
Do not fill past the Max Fill line on the tray.
To change reservoir water:
 Unplug the saw.
 Remove the drain plug and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
RUBBER
BOOT
FILL LINE
Fig. 15
WATER
RESERVOIR
Fig. 16