FAZUA evation i.o Manual Original página 20

EN
When the Battery Pack (1) is not within the charging temperature range, it will
not charge even when the Charger is connected. It will wait until the charging
temperature is reached before starting.
Charge-control indicator
When the Battery Pack (1) gets switched on, the start-up animation will be
shown on the charge-control indicator (3). After that, the LEDs will shortly show
the state-of-charge (3) of the Battery Pack (1).
Once the Battery Pack (1) is on, the state-of-charge can be checked by
briefly pressing the on/off button (2).
Each LED corresponds to 20% of the capacity. When charge is full, all five LEDs
light up. However, when the charge is empty, only the last LED will light up
intermittently. The state-of-charge of the Battery Pack (1) is also shown on the
Remote (see Remote Instructions).
Inserting/Removing the Battery Pack
Warning! Make sure both Battery Pack (1) and Drivepack (7) are
clean, otherwise, the friction created by the dirt may complicate
this operation.
To insert the Battery Pack (1) into the Drivepack (7), hold the Drivepack
(7) in one hand and Battery Pack (1) in the other hand. Make sure the
connector to the Drivepack (5) is facing the battery slot (8). Bring the
two together and gently let the Battery Pack (1) slip into the battery
slot (8) of the Drivepack (7) (Action A). Once the Battery Pack (1) is completely
inserted, the fastening lid (6) will automatically lock the Battery Pack (1).
To remove the Battery Pack (1) from the Drivepack (7), press down the
fastening lid (6) and, at the same time, pull the Battery Pack (1) out of the
battery slot (8) (Action B).
36
Operation
Note! The Battery Pack (1) is protected against short-circuit,
overheating, overcharge
protection may automatically shut down the the Battery
Pack (1) if there is a risk.
Switching Battery Pack On/Off
The Battery Pack (1) can equally be switched on/off when inserted/non-
inserted in the Drivepack (7).
To switch on the Battery Pack (1), press the on/off button (2). The LEDs at the
charge-control indicator (3) will show a start-up animation and then shortly
the state-of-charge.
To switch off the Battery Pack (1), press and hold the on/off button (2) for 2 s.
The LEDs at the charge-control indicator (3) will show a shutdown animation
and Battery Pack (1) will switch off.
If your eBike reaches inactivity, your Battery Pack (1) will switch off to save
the remaining energy (see Drivepack Inactivity Instructions). Equally, if
a standalone Battery Pack (1) spends 12 h without being inserted in a
Drivepack (7), connected to a Charger or having its button pushed, it will
switch off to save the remaining energy
and deep discharging. This
37
EN