Learning; Speed - Desoutter EAP1.5-15 Serie Manual Del Operador

1.2.5 - Learning

It is recommended to use the learning function to programme the tool. This function is used to easily optimise all
the tightening parameters, including parameters which can only be reached through the PDA (run down torque,
angle tolerance, etc.). If at the end of the learning you are not satisfied with the speed level, you can change it by
selecting the speed parameter.
Learning begins.
1. Tighten the first assembly. Result 1
End of step 1
2. Tighten the second assembly. Result 2:
End of step 2
3. Tighten the third and last assembly. Result 3:
Learning is done.
Then you can:
• either press for at least 3s to go back in tightening mode,
• or briefly press to modify the speed parameter.
If you perform the learning with only one assembly, you can loose it using
If during the learning the result is not OK, the tool goes back to the beginning of the learning process.
If after the 1st or the 2nd tightening you do not want to go on, press
of the learning process.

1.2.6 - Speed

The speed level is set automatically when the assembly is learnt. It is modified when the speeds learnt are not com-
pletely satisfactory.
The speed level can be set between 1 and 10 (1=slow, 10=fast). For each speed level there are one rundown speed
and one final tightening speed. The display displays successively the speed (1 to 10), the rundown speed (rpm) and
the final tightening speed (rpm). These speed pairs are optimised for each tool type and to match all types of assem-
bly. Thus the tightening is more precise, the operator comfort is improved, the operation shocks are reduced, the
cycle time is optimised and the tool overheating is reduced.
1 From the speed mode, press
the speed level.
2 Press to validate.
EAP/EDP
:
Torque Min. angle tolerance
or to choose
Torque
Torque
Max. angle tolerance
. Then the tool goes back to the beginning
Part no 6159936431
Issue no 06
Language English
Date 09/2009
24
Page 11 /
Angle
Angle
Speed parameter
display
.