Desoutter EAP1.5-15 Serie Manual Del Operador página 20

Part no 6159936431
Issue no 06
Language English
Date 09/2009
24
Page 18 /
Error
E411 Exceeding of the maximum engine
temperature
completes the cycle in progress
E412 Handle overheating
E416 Engine temperature sensor faulty
E417 DSP board temperature sensor faulty The temperature sensor on the DSP board registers an abnormal
E418 No communication with the torque
transducer
>E500 E2PROM access error
E501 Error of data size sent to the EEPROM
E502 Reading error of CRC on "Identification - Tool - Calibration" parameters
E503 Reading error of CRC on "Code - Station - Sequence - Cycle" parameters
E504 Reading error of CRC on "Maintenance" parameters
E511 Reading error of "Identification - Tool - Calibration" parameters
E512 Reading error of "Code - Station - Sequence - Cycle" parameter
E513 Reading error of "Maintenance" parameters
E514 Writing error of STATION parameter
E515 Writing error of ACCESS CODE parameter
E516 Writing error of CYCLE parameter
E517 Writing error of SEQUENCE parameter
E519 Writing error of the error table
E521 Writing error of the cycle manually set up
E522 Writing error of target torque when learning
E524 Software version
E525 Writing error of CALIBRATION parameters
E526 Writing error of the torque coefficient
E527 Writing error of linearity table
E528 Writing error of motor offset coefficients
E529 Writing error of CRC on "Identification - Tool - Calibration" parameters.
E530 Writing error of CRC on "Code - Station - Sequence - Cycle" parameters
E531 Writing error of CRC on "Maintenance" parameters
E532 Writing error of the tool option
E533 Writing error of the tool type
Description
Wait for the tool to cool down. The tool can tighten again when the
(60°C); the tool temperature is lower than 55°C. This means that the tool tightening rate
is too big or that the ambient temperature is higher than the usual
temperature. Make sure that the tightening rate is adapted to the
maximum tightening rate recommended by the manufacturer. Make sure
that the tightening parameters (run down torque, speed) have been
optimised. Perform a learning for the assembly.
Never close up ventilation inlet, make sure the fan is in operation (a faint
noise is audible). The tool can tighten again when the temperature is
back to normal.
The temperature sensor on the hall board registers an abnormal
temperature (T<-10°C ; T>110°C). The tool has stopped. Check the hall
board connection / change the hall board / contact our customer service.
temperature (T<-10°C ; T>110°C). The tool has stopped. Change the
DSP board / contact our customer service.
This error appears when the communication between the torque
transducer and the DSP is interrupted for any reason. It may be a flat
cable fault, a disconnection of the flat cable or a torque transducer
electronic fault.
The tool data are no longer available (E2PROM access faulty, data
partially or totally modified or lost). Contact our customer service.
EAP/EDP
Checking/Actions