Assembly Actuator With Ball Valve 546 - GF EA 04 Manual Instrucciones

Electrical actuator type EA04

7.2 Assembly actuator with ball valve 546

The electrical actuator can built on the ball valve type 546 with the appropriate
coupling piece and appropriate adapter:
Insert actuator adapter (4) on the valve shaft. Ensure that the
actuator adapter that matches the actuator square attachment is
used!
Connect actuator and valve. To do so, insert the actuator
adapter in the square attachment of the actuator.
Fix the automated unit using the two screws (7) and washers (8).
Insert the two screws (1) into the
hexagonal attachments in the
adapter panel (2).
Fix adapter panel (2) with the four
screws (3)
(F03‐F04 = size M5x10, F05 = size
M6x12, F07 = size M8x20).
Insert assembly panel (6) on the
valve. Fix assembly panel with the
four screws (5).
Installation
35