Easy Home VC9389 Manual Del Usuario página 10

How to clean carpet
1. Plug the power cord into and electrical outlet and turn the carpet cleaner on
using the power switch on the side of the unit.
2. Step on the handle release pedal on the back of the carpet
cleaner to lower the handle into the cleaning position.
3. Squeeze the release trigger and pull the carpet cleaner in a
backward motion. Release the trigger and using a steady,
moderate forward and backward motion (about 1 second per foot), push the
carpet cleaner in the same path to agitate and remove the dirty water and
solution from the carpet. NOTE: For heavily soiled areas, repeat if necessary.
4. Make sure to work in a direction that ensures you will not walk on wet
carpeting.
How to empty the dirty water tank
1. Unplug the carpet cleaner.
2. Unlock the dirty water tank by pressing the locking latch and lifting up on the
handle at the same time. (see step 1)
3. Unscrew the tank cap, located on the bottom of the tank, by turning it
counterclockwise. (see step 2)
4. Empty the dirty water tank, rinse well and replace the cap.
5. Replace the dirty water tank by pushing down on the handle until the locking
latch clicks into place. (see step 3)
Step 1
After cleaning
Allow the carpet to dry thoroughly before walking on it, place clean white towels
on the carpet first. After it is thoroughly dry, vacuum the carpet.
10
Step 2
User instructions
Step 3