Technical Data; Adjustment Of Land Width - ALFRA SKF 63-15 Instrucciones De Operación


The ALFRA bevel milling machine SKF 63-15 is a unit for the preparation of welds, bevelling of
metallic materials resp.

The low weight (please compare with our competition) enables the use on almost every work
place and a rattling-free, steady milling operation.

The machine is suitable for milling steel, VA, cast iron and nonferrous heavy metal by one-hand
operation.

To make operation easier the SKF 63-15 is equipped with a wheel-table plate.
4.1

Technical Data

230 V AC, 50 Hz – other voltages / frequencies on request
Motor/Voltage:
with overload protection and restart barricade.
Capacity: 1100 W
Land Width: 15 mm max., progressively adjustable
Bevel Angle: 15-20-30-45-60° progressively adjustable
2 units off disk milling cutters  63 mm, each with 6 pieces indexable inserts.
Tools:
5.

Adjustment of Land Width

The bevel milling machine is factory adjusted to a land width of 2 mm.
In order to adjust your required land with, detach both fastening screws (13) underneath the star
handle.
By turning the star handle (12) you can now shift the housing within a range of 0 - 15 mm.
Land widths exceeding 15 mm are not recommended. In order to protect machine and tools you
should generally advance land widths of more than 5 mm in multiple steps.
Marks on the scale sheet
(corresponds to
After adjustment it is imperative to tighten the fastening screws again.
Star handle
screw (12)
Adjustment of
Land Width (13)
Scale right
(20B)
Adjustment of
Bezel Angle (30)
I I I I enable the reading of the land width.
0 7 14 22 mm appr. with a 45° bevel angle)
Rotation Speed: 2870 min
Weight: 21 kg
Dimension (L x W x H): 440x200x280 mm
-1
21