Advance Recommendation; Changing Of Indexable Inserts - ALFRA SKF 63-15 Instrucciones De Operación

5.3

Advance Recommendation

Material
General construction steels up to 850 N/mm²
Hardened steels over 850 N/mm²
Stainless and acid-proof steels up to 600 N/mm²
Steel casting up to 450 N/mm²
Cast iron up to 400 N/mm²
Aluminium (special indexable inserts required, available on
separate request)
5.4 Changing of the Indexable Inserts
Take care that the mains plug is drawn!
ATTENTION:
Changing or turning of indexable inserts only in cooled down condition!
a) For the changing, turning resp., of the indexable inserts unscrew the two hexagon sockets
screws (13) which serve for the land width fixing.
b) Lift cover off from motor.
c) Bend up lock washer (17) on the groove nut (18).
d) Fix milling head receiver by means of the 30 mm spanner included in the package.
e) Unscrew and detach groove nut (18) by means of the sickle spanner included.
f) Take up the lock washers (17).
g) Take up the milling heads (40).
Motorcover
Advance Recommendation
0,8 – 1,0 m / min
0,75 m / min
0,5 m / min
0,6 m / min
0,8 – 1,0 m / min
0,4 m / min
groove nut (18)
Lock washer (17)
23