Getting Started - Texas Instruments TI-5640 Manual De Instrucciones

Getting Started

Installing the Paper Roll
1. Lift the paper holder so that it extends behind the printer compartment.
2. Remove the printer compartment cover and remove any packing
materials from the printer compartment.
3. Replace the printer compartment cover.
4. Make sure the calculator is plugged into an electrical outlet.
5. Move the
POWER
6. Place the paper roll on the paper holder.
7. Insert the end of the paper into the paper slot on the back of the
calculator as shown. To avoid paper jams, use quality bond paper.
8. While feeding the paper into the slot, press and hold &.
To prevent damaging the printer (which may void the warranty), when
Note
operating the calculator without paper, move the
Replacing the 2-Colour Ink Ribbon
1. Remove the paper roll and press & to run out any remaining paper.
2. Move the
POWER
3. Remove the printer compartment cover.
4. Lift each ribbon spool until the ribbon is clear of the printer.
switch to .
ON
switch to .
OFF
1
switch to
PRINTER
.
OFF