Important - Sears Kenmore 66513293K110 Instrucciones De Instalación

IMPORTANT: The drain hose connection ofthedisposer ora
waste teemust b emade before thedrain trapandat least
20"(50.8 cm)above thefloorwhere t hedishwasher will be
installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
Option A_ Waste disposer - no air cjap
2.
3.
Using a hammer and screwdriver,
knock plug into disposer.
Use needle-nose pliers to remove
plug.
Attach drain hose to disposer inlet
with large blue drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
Option B, No waste disposer - no air gap
Mue ..........
Drai
i i!
hose
1. Fit rubber end of drain hose to
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
2°
Attach rubber end of drain hose to
waste tee with a large blue drain
hose clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 11/2 '' to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
Option C_Waste disposer - with air gap
Drain trap
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
4° Attach drain hose to air gap with
large blue drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
If the drain hose was cut, use a 11/2 ''
to 2" (3.8 to 5 cm) screw-type
clamp (not provided).
5°
Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap
to disposer inlet.
10