Sears Kenmore 66513293K110 Instrucciones De Instalación página 19

Green clamp --
Black drain hose Drain hose
connectc
Drain hose stop
Stop
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of
the drain hose. Push the new drain hose into the black drain
hose connector up to the drain hose stop.
Using pliers, squeeze open the small green drain hose clamp
and slide onto connector between stops.
After hose is connected, remove towel.
NOTE: If the power supply cord was connected earlier, proceed
to "Secure Dishwasher in Cabinet Opening" section.
Option B0Direct Wire:
_ 11
.
into terminal box |
/
Route cable so that it does not touch dishwasher motor or lower
part of dishwasher tub. Pull cable through UL Listed/CSA
Approved strain relief in terminal box. Strain relief is not
supplied with the dishwasher. Owner must purchase a 7/8" screw-
in type strain relief.
Select UL Listed/CSA Approved twist-on wire connectors (not
included) rated to connect your household wiring to 16-gauge
dishwasher wiring.
19