Index - EnGenius EP802 Manual De Usuario

Use CHANGE left soft key to select and confirm on or off. The
(1)
Re: When setting "on", the EP802 will automatically hang up if the far
end caller hung up already. However, this function depends on if
there is "dial tone or busy tone" signal sent out by PBX or PSTN,
after the call hung up.
g. Press 7 to Set Time to support DTMF Caller ID:
Use SAVE left soft key to select and confirm the Date and Time
(1)
you have set (see Set Time operation on page 20).
8. Press 7 to register, de-register handset and set Multi-Base: see Handset
Registration operation on Page 36, and Multi-base Setting on Page 48.
9. Press 8 to set Menu Display:
To avoid mis-setup of Call Settings (MENU-4), Phone Settings (MENU-5)
and Base Settings (MENU-6), you can hide these menus, so that other
handset users won't have chance to mis-settup these settings.
Re: When entering the Menu Display, you have to enter password first.
a. Press 1 to set hiding/un-hiding of the Call Settings menu.
(1) Use CHANGE left soft key to select and confirm on or off.
b. Press 2 to set hiding/un-hiding of the Phone Settings menu.
(1) Use CHANGE left soft key to select and confirm on or off.
c. Press 3 to set hiding/un-hiding of the Base Settings menu.
(1) Use CHANGE left soft key to select and confirm on or off.
d. Press 4 to set hiding/un-hiding of the Multi-base Settings menu.
(1) Use CHANGE left soft key to select and confirm on or off.
Re: Select "On" means the menu will be displayed on screen. Select "Off"
means the menu will be hidden.
~57~

Index

2
2-Way Intercom, 14, 29
A
Adjusting Receiver (Earpiece) Voice Volume, 33
Adjusting Handset Speakerphone Voice Volume, 33
Adjust Handset Microphone Gain, 50
Adjust Headset Ring, 51
Area Code, 19, 54
B
Base ID, 48
Base Illustration, 21
Base Operation, 27
Base PIN, 18, 19, 20
Base Station, 5, 6, 9, 10, 14, 15, 20, 22, 25, 26, 27, 28, 30, 36, 43
Base Station Features, 22
Base Station Installation, 25
Battery, 5, 7, 10, 24, 26, 27, 35
Battery Recharge and Replacement, 35
Battery Safety Instructions, 7
Battery Strength, 13
Block Incoming Call, 43
Block Outgoing Call, 43
Broadcast, 14, 16, 18, 31, 44, 49
Broadcasting a Group of Handsets, 30
Broadcasting all Handsets, 30
Broadcasting an Individual Handset, 31
BS Selection, 49
C
Call Barring, 16, 18, 42, 43, 54
Call Log, 16, 17, 46, 47
Call Timer, 17
Call Transfer, 33, 37
Call Hold, 17
Caller ID, 15, 20, 31, 32, 46, 47, 50, 55, 56
Call in-progress, 13
Call Manager, 49, 50, 54
Call Settings, 16, 18, 20, 37, 49, 50, 51, 54, 57
Call Waiting, 14, 15
Call Waiting with Caller ID, 15, 55
~58~