FujiFilm Instax Share SP-2 Manual De Instrucciones página 26

■ Wireless data (images) may be intercepted by third parties.
The security of data transmitted over wireless networks is not guaranteed.
■ Do not use the device in locations subject to magnetic fields, static electricity, or radio interference.
Do not use the transmitter in the vicinity of microwave ovens or in other locations subject to magnetic fields, static electric-
EN
ity, or radio interference that may prevent reception of wireless signals. Mutual interference may occur when the transmitter
is used in the vicinity of other wireless devices operating in the 2.4 GHz band.
■ The wireless transmitter operates in the 2.4 GHz band using DSSS and OFDM modulation.
■ This device operates on the same frequency as commercial, educational, and medical devices and
wireless transmitters.
It also operates on the same frequency as licensed transmitters and special unlicensed low-voltage transmitters used in RFID
tracking systems for assembly lines and in other similar applications.
■ To prevent interference with the above devices, observe the following precautions.
Confirm that the RFID transmitter is not in operation before using this device. Should you observe that the device causes
interference in licensed transmitters used for RFID tracking, immediately choose a new operating frequency for this device to
prevent additional interference. If you notice that this device causes interference in low-voltage RFID tracing systems, contact
a FUJIFILM representative.
■ Certification marks acquired by the printer are located inside the film chamber.
26
instax_BO-B_6lang.indb 26 4/13/2016 10:33:42 AM