Domo DO7282S Manual De Instrucciones página 32

DO7282S
PARTS
1. On/off switch
2. Cord rewinder
3. Suction power regulation
4. Dust bag lid
5. Indication for bag change
6. Clip opening dust bag
compartment
7. Floor brush
8. Flexible hose
ASSEMBLY
1. Attach the hose to the hose connection of the vacuum cleaner.
2. Attach the metal tube to the hose.
3. Connect the floor brush to the metal tube.
INSTRUCTIONS FOR USE
1. Button to rewind the cable:
Pull the cord out of the appliance as far as necessary. Make sure you don't exceed
the red marking on the wire. Keep hold of the plug during the rewinding of the
cord. You can press the button with your foot to rewind the cable.
2. Suction power regulation:
Use the slider button to adjust the suction power of your vacuum cleaner.
3. When the red marking that indicates the change of the dust bag becomes visible,
you should check the following:
▪ Is the dust bag full? If so change it.
▪ Is the dust bag blocked? If so remove the blockage immediately.
▪ Is the floor brush, tube or hose blocked? If so remove the blockage
immediately.
4
8
6
32
5
7
2
3
1