baltur ACS 355 Guía De Iniciación página 18

Operation
You operate the control panel with the help of menus and keys. You select an option, e.g. operation mode or parameter, by
scrolling the and
With the key , you return to the previous operation level without saving the made changes.
The Basic Control Panel has five panel modes: Output, Reference, Parameter, Copy and Fault. The operation in the first four
modes is described in this chapter. When a fault or alarm occurs, the panel goes automatically to the Fault mode showing the
fault or alarm code. You can reset the fault or alarm in the Output or Fault mode (see chapter Fault tracing).
When the power is switched on, the panel is in the Output mode, where you can start, stop, change the direction, switch
between local and remote control and monitor up to three actual values (one at a time). To do other tasks, go first to the Main
menu and select the appropriate mode.
How to do common tasks
The table below lists common tasks, the mode in which you can perform them and the page number of the user manual where
the steps to do the task are described in detail.
Task
How to switch between local and remote control
How to start and stop the drive
How to change the direction of the motor rotation
How to browse the monitored signals
How to set the speed, frequency or torque reference
How to change the value of a parameter
How to select the monitored signals
How to reset faults and alarms
How to copy parameters from the drive to the control panel
How to restore parameters from the control panel to the drive
arrow keys until the option is visible in the display and then pressing the key
0006081262_200906
FREQUENCY CONVERTER
Output, Fault
18 / 58
Mode Page of user
manual
Any
Any
Any
Output
Reference
Parameter
Parameter
Copy
Copy
56
56
56
57
58
59
60
257
62
62