Parameter Mode; Copy Mode - baltur ACS 355 Guía De Iniciación

Parameter mode

In the Parameter mode, you can:
• view and change parameter values
• select and modify the signals shown in the Output mode
• start, stop, change the direction and switch between local and remote control.
How to select a parameter and change its value

Copy mode

The Basic Control Panel can store a full set of drive parameters and up to three user
sets of drive parameters to the control panel. The control panel memory is nonvolatile.
In the Copy mode, you can do the following:
— Copy all parameters from the drive to the control panel (uL- Upload). This includes all defined user sets of parameters
and internal (not adjustable by the user) parameters such as those created by the ID Run.
— Restore the full parameter set from the control panel to the drive (rE A - Restore All). This writes all parameters, including
the internal non-user-adjustable motor parameters, to the drive. It does not include the user sets of parameters.
Note: Only use this function to restore a drive, or to transfer parameters to systems that are identical to the original
system.
19 / 58
0006081262_200906
FREQUENCY CONVERTER