Mounting The Device - Luxibel LX301 Manual Del Usuario

•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device is protected against extreme heat (see Technical
Specifications), dust and moisture. Respect a minimum distance of 0.5m between the device's light
output and any illuminated surface.
•
Use an appropriate safety cable to fix the device (e.g. VDLSC8).
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
•
The installation has to be approved by an expert before the device is taken into service.
•
Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
4. Features
•
continuous blinder effect with auto fades
•
smart integrated heat control eliminates cool down time
•
variable flash duration, intensity and rate
•
special preprogrammed effects
•
5600K
•
DMX-controlled in 1, 3, or 4 channel mode
•
optional controller: LX302.
5. Installation
5.1

Mounting the Device

•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
5.2 Lamp Power Setting
The LX301 can be set at high or low power setting. The high power setting provides you maximum flash
intensity, the low power setting reduces the output by approximately 50% and extends the lamp lifetime.
Select the desired setting through DIP switch 6. The setting applies regardless of the other switch
setting.
1 2
↓
ON
high power
V. 01 – 08/06/2012
3 4 5
LX301
6
↓
ON
3
1 2 3
low power
4 5 6
©Velleman nv