EIBENSTOCK EPG 400 WP Instrucciones De Servicio página 13

Technical Data
Plaster milling machine EPG 400 WP
Rated voltage:
Power input:
Rated current:
Order number
Frequency:
Rated speed:
No load speed:
Disc diameter:
Spindle connection:
Protection class:
Degree of protection:
Weight:
Interference suppression:
Case including plaster milling machine with base plate, sponge board and
manual.
Application for Indented Purpose
When used with the appropriate equipment, the plaster milling machine EPG
400 WP is suitable for machining lime-cement- and gypsum-based surfaces.
Available Accessories (Fig. Page. 3):
Pos. Order No Article
1 37721000
2 37722000
3 37725000
4 37729000
5 37726000
6 37724000
7 37728000
8 37727000
Supply
Base plate (Klett)
Ø 370 mm
Sponge board
Ø 400 mm
Sponge rubber disk
Ø 400 mm
Felt disc
Ø 395 mm
Plaster plane
Ø 385 mm
Scratch disk
Ø 370 mm
smoothing plate
Ø 385 mm
Sanding wheel P24
Ø 370 mm
230 V ~
500 W
2,3 A
0650L000
50 - 60 Hz
0 - 60 rpm
0 – 110 rpm
370 mm (Base plate)
special
II
IP 20
about kg
EN 55014 and EN 61000
basic holder for all Klett
disks
for smoothening lime-
cement-based plasters
for smoothening lime-
cement- and gypsum-based
plasters
For rubbing interior / exterior
lime-cement
for smoothening lime-
cement-based plasters
for sgraffito purposes
for smoothening plaster and
concrete
for sanding insulation
boards
13
110 V ~
500 W
4,8 A
Application