Schumacher Electric SEM-1562A-CA Manual Del Usuario página 7

USING THE QUICK-CONNECT CABLE CONNECTORS
Connect either of the two (2) output cable leads to the charger. Make sure to
place the charger on a dry, non-flammable surface.
WARNING: Never connect the clamp and ring terminal connectors together
for use in other applications, such as external battery or other power source
charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
USING THE 50 AMP BATTERY CLAMPS
1. Connect the end of the charger output cable to the end of the battery
cable, quick-connect and clamps.
2. Follow the steps in sections CHARGING A BATTERY IN THE VEHICLE
and CHARGING A BATTERY OUTSIDE OF THE VEHICLE to connect
the output clamps to the battery.
3. Connect the charger to an electrical power outlet.
USING THE RING CONNECTORS
1. To permanently attach to a battery, loosen and remove each nut from the
bolt at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery
terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6. Connect the charger to an electrical power outlet.
AUTOMATIC CHARGING MODE
When an automatic charge is performed, the charger switches to the maintain
mode (see below) automatically after the battery is charged.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging
aborts, the charger's output is shut off and the CHARGING
will flash. To reset after an aborted charge, unplug the charger from the AC
outlet, wait a few moments and plug it back in.
DESULFATION MODE
Desulfation could take 8 to 10 hours. If desulfation fails, charging will abort and
the CHARGING
COMPLETION OF CHARGE
Charge completion is indicated by the CHARGED
pulsing, the charger has switched to the maintain mode of operation.
(yellow) LED will flash.
• 7 •
(yellow) LED
(green) LED. When