Inserting Batteries - Minelab SDC 2300 Manual De Instrucciones

Inserting Batteries

The SDC 2300 requires four C cell batteries for
operation. Only use high quality alkaline or
rechargeable batteries. Minelab recommends
that only rechargeable batteries with a
capacity of 4000 mAh or greater be used.
Rechargeable batteries have specific charge/
discharge maintenance requirements, which
should be strictly followed to ensure maximum
battery life.
Tips:
Always ensure that your rechargeable
batteries are at full charge.
Only use high quality batteries.
The battery compartment is located at the rear
of the detector. To open the compartment,
twist the knob in a counter-clockwise
direction, and then pull the door back as
shown.
Insert the batteries. Refer to the battery
orientation diagram on the side of the
detector to ensure that the batteries are
inserted correctly.
Batteries
Close the battery door and twist the knob
clockwise as shown.
The waterproof seal on the battery
door must be free of contamination
prior to submerging the detector.
Always clean the seal and its mating
surface and check for damage prior
to underwater use otherwise serious damage can
be caused to your detector.
5