DeWalt D55151 Manual De Instrucciones página 5

,t_DANGER: RISK OF EXPLOSION OR FIRE
WHAT CAN HAPPEN HOWTO PREVENT iT
• It is normal for electrica! _ Always operat e the compres_
contacts within the motor Sor in a well ventilated area
and pressure switch to free of combustible materials,
spark, gasoline, or solvent vapors.
• If electrical sparks from • If spraying flammable materi-
compressor come into con- als, locate compressor at
tact with flammable vapors, east 20 feet 16.1 m) away
they may ignite, causing fire from spray area. An addi-
or explosion, tional length of hose may be
required.
- Store flammable materials q
a secure location away from
compressor.
• Restricting any of the com- • Never place objects against
pressor ventilation openings or on top of compressor
will cause serious overheat- • Operate compressor in
ing and could cause fire. an open area at least 12"
(30.5 cm) away from any
wall or obstruction that would
restrict the flow of fresh air to
the ventilation openings.
• Operate compressor in a
clean, dry well ventilated area.
Do no_operate unit indoors or
in any confined area.
Unattended operation of
this product could result in
personal injury or property
damage. To reduce the risk
of fire, do not allow the
compressor to operate unat-
tended.
• Always remain in attendance
with the product when it is
operating.
• Always turn off and unplug
unit when not in use.
ADANGER: RISK TO BREATHING (ASPHYXIATION)
WHAT CAN HAPPEN HOWTO PREVENTIT
, The compressed air directly - Air obtained directly from the
from your compressor is not compressor should never
safe for breathing. The air be used to supply air for
stream may contain carbon human consumption. In order
monoxide, toxic vapors, to use air produced by this
or solid particles from the compressor for breathing
air tank. Breathing these suitable filters and in-line
contaminant's can cause safety equipment must be
serious injury or death, properly installed. In-line
filters and safety equipment
used in conjunction with the
compressor must be capable
of treating air to all applicable
local and federal codes prior to
human consumption