Power Connections; Motor Specifications; Grounding Instructions - Delta 31-481 Manual De Instrucciones

A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and
should be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords
which have 3-prong grounding type plugs and matching receptacle which will accept the machine's plug. Before
connecting the machine to the power line, make sure the switch (s) is in the "OFF" position and be sure that the
electric current is of the same characteristics as indicated on the machine. All line connections should make good
contact. Running on low voltage will damage the machine.
dO NOT ExPOSE ThE MAChINE TO RAIN OR OPERATE ThE MAChINE IN dAMP LOCATIONS.
Your machine is wired for 230 volts, 60 HZ alternating current. Before connecting the machine to the power source,
make sure the switch is in the "OFF" position.
ThIS MAChINE MUST BE gROUNdEd whILE IN USE TO PROTECT ThE OPERATOR FROM
ELECTRIC ShOCk.
1. All grounded, cord-connected machines:
In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to
reduce the risk of electric shock. This machine is equipped with an electric cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
Do not modify the plug provided - if it will not fit the outlet, have the proper outlet installed by a qualified electrician.
Improper connection of the equipment-grounding conductor can result in risk of electric shock. The conductor with
insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor.
If repair or replacement of the electric cord or plug is necessary, do not connect the equipment-grounding conductor
to a live terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not completely understood,
or if in doubt as to whether the machine is properly grounded.
Use only 3-wire extension cords that have 3-prong grounding type plugs and matching 3-conductor receptacles that
accept the machine's plug, as shown in Fig. A.
Repair or replace damaged or worn cord immediately.
IN ALL CASES, MAkE CERTAIN ThE RECEPTACLE IN QUESTION IS PROPERLY gROUNdEd.
IF YOU ARE NOT SURE, hAvE A QUALIFIEd ELECTRICIAN ChECk ThE RECEPTACLE.

POwER CONNECTIONS

MOTOR SPECIFICATIONS

gROUNdINg INSTRUCTIONS

FIg. A
5
FIg. B