Functional Description; Product Specifications; Unpacking - Delta 31-481 Manual De Instrucciones

®
Model 31-481 DELTA
processes in a single pass. This machine features an adjustable height automatic feed table and comes with 80-grit
and 120-grit pre-cut sanding belts already installed. This dual drum sander is powered by a 3HP continuous duty
sealed motor with a variable speed feed that enables you work at 3-20 S.F.P.M. The wide feed belt accepts stock as
big as 25 ½" and allows you to sand pieces up to 12 ¼" thick.
dRUM MOTOR SPECIFICATIONS
Type
Horsepower
Amps
Voltage
Phase
Hertz
RPM
BELT FEEd MOTOR SPECIFICATIONS
Type
Horsepower

PROdUCT SPECIFICATIONS

Maximum sanding width
Maximum board thickness
Minimum board thickness
Minimum board length
Feed Speed
The machine is heavy, be careful when removing it from the shipping container! Failure to comply
may cause serious injury and/or damage to the sander and/or property!
®
Your DELTA Dual Drum Sander comes packed in a single container. Use a safety strap to avoid tip over when lifting
machine. Check shipping carton and machine for damage before unpacking.
Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton.
Always check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a
clean work surface and check that all parts are present and in good condition:
dESCRIPTION (QUANTITY)
Delta 26" Dual Drum Sander (1)
12mm Open End Wrench (1)
Elevation Handle (1)
5mm Hex Wrench (1)
6mm T-Handle Wrench (1)
2mm T-Handle Wrench (1)
Elevation Bracket (1)

FUNCTIONAL dESCRIPTION

26" Dual Drum Sander is specifically designed to handle both rough and final sanding
PROdUCT SPECIFICATIONS
Induction Ball bearing/
Continuous Duty
3HP
16A
230V
Single
60Hz
3,450
Universal
1/6
25-1/2"
12-1/4"
¼"
6"
3-20 FPM (variable)

UNPACkINg

Compare the items to inventory figures; verify that all items are accounted
for before discarding the shipping box. Report any missing or damaged
parts to your distributor or dealer. Prior to tool assembly and use, read
this manual thoroughly to familiarize yourself with proper assembly,
maintenance and safety procedures.
Remove any protective materials and coatings from all of the parts and the
drum sander. The protective coatings can be removed by spraying WD-40
on them and wiping it off with a soft cloth. This may need to be redone
several times before all of the protective coatings are removed completely.
only be turned "ON" after all the parts have been obtained and installed
correctly.
Number of Sanding Drums
Drum Size
Drum Speed
Dust Ports
PROdUCT dIMENSIONS
Footprint
Length
Width
Height
Weight
ShIPPINg dIMENSIONS
Carton Type
Length
Width
Height
gross Weight
If any parts are missing, do not attempt to plug in the power
cord and turn "ON" the machine. The machine should
7
2
5" x 26"
1,550 RPM
2-4"
17-3/4" x 43"
31"
46"
53"
485 lbs.
Wooden Crate
33"
48"
55"
535 lbs.