Install Leveling Legs; Remove Foam Packing (24" Models) - Whirlpool W10843728A Instrucciones De Instalación

Install Leveling Legs (27" models) Install Leveling Legs (24" models)
1.
Prepare to install leveling feet
Prop up the front of the washer/dryer Prop up the front of the washer/dryer
about 4" (102 mm) with a wood block
or similar object that will support the
weight of the washer/dryer. Then screw the locknut onto each
foot to within 1" (25 mm) of the foot base.
2.
Install front leveling feet
Screw the feet into the threaded holes at Screw the feet into the threaded holes at
the front corners of the washer/dryer until
the jam nuts touch the washer.
NOTE: Do not tighten the nuts until the washer/dryer is level.
Tilt the washer/dryer back and remove the wood block. Gently
lower the washer/dryer to the fl oor.
To protect the fl oor, use a large fl at piece of cardboard from the
shipping carton. Gently place the washer/dryer on its side, on
the cardboard.
1"
(25 mm)
Push legs into holes in rear corners until they snap into place.
Check adjustability of rear legs by pushing in one leg. The
other leg should come out. Check both legs. If they do not
move freely, repeat procedure.
Examine front leveling legs; fi nd diamond marking. Screw front
legs by hand into holes in triangular braces in front corners.
Use wrench to fi nish turning the legs until diamond marking is
no longer visible. Gently stand the washer/dryer upright.

Remove Foam Packing (24" models)

Open the washer lid. The latch under the dryer will keep
the lid open. Pull the foam packing ring out of the washer.
NOTE: Keep the foam ring and use it when transporting
your washer/dryer. This packing material is used to keep
the washer tub stable during transport.
1.
Install rear leveling legs
2.
Install front leveling legs
1.
Pull foam packing ring out of washer
13