Sears Kenmore Elite 106.5118 Serie Manual De Uso Y Cuidado página 13

Refrigerador de dos puertas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Style 3
1.
Unplug
refrigerator
or disconnect
power.
2.
Remove
and discard
the black
nylon
plug from
the gray
water
tube
on the rear of the refrigerator.
3.
If the gray
water
tube
supplied
with
the refrigerator
is not
long
enough,
a 1/4" x 1/4" (6.35 mm x 6.35
mm) coupling
is
needed
in order
to connect
the water
tubing
to an existing
household
water
line. Thread
the provided
nut onto
the
coupling
on the end of the copper
tubing.
NOTE:
Tighten
the nut by hand.
Then tighten
it with
a
wrench
two more turns.
Do not overtighten.
A
B
C
D
E
F
G
A. Refrigerator
water tubing
E. Ferrule {purchased)
B. Nut {provided)
F. Nut {purchased)
C, Bulb
G. Household
water line
D. Coupling
{purchased)
4.
Turn shutoff
valve
ON.
5.
Check
for leaks.
Tighten
any nuts or connections
(including
connections
at the valve)
that leak.
Complete
the Installation
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
sta
Cea ' Fow
F
(on so_>e n,¢odes}
On some models,
your
refrigerator's
accessory
packet
includes
an air filter,
which
must be installed
prior
to use. On some
models
the air filter
is already
installed
at the factory.
The air filter
reduces
the buildup
of odors.
This helps to maintain
a cleaner
environment
inside
the refrigerator.
Installing
the Air
Filter
(on some
models)
The filter
should
be installed
behind
the vented
door,
which
is
located
(depending
on your
model)
along
either
the rear or left
interior wall
near the top of the refrigerator
comoartment.
1.
Remove
the air filter
from
its packaging.
2.
Lift open
the vented
door.
3.
Snap
the filter
into place.
Installing
the Filter Status Indicator
(on some models)
The filter comes with a status indicator,
which should be
activated
and installed at the same time the air filter is installed.
I.
Plug into a grounded
3 prong
outlet.
2.
Flush the water
system.
See "Prepare
the Water
System"
or
"Water
and Ice Dispensers."
NOTE:
Allow
24 hours to produce
the first
batch
of ice. Allow
3 days to completely
fill
ice container.
1.
Place
the indicator
face-down
on a firm,
flat
surface.
2.
Apply
pressure
to the bubble
on the back of the indicator,
until the bubble
pops to activate
the indicator.
3.
Lift open
the vented
air filter
door. There are notches
behind
the door.
Slide
the indicator
down
into the notches,
facing
outward.
13

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido