Accessories; Water Filter Certifications - Sears Kenmore Elite 106.5118 Serie Manual De Uso Y Cuidado

Refrigerador de dos puertas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cut Hazard
Use a sturdy glass when dispensing
ice.
Failure to do so can resuR in cuts.
Is the ice dispenser
stalling
while
dispensing
"crushed"
ice?
Change
the ice button
from
"crushed"
to "cubed."
If cubed
ice dispenses
correctly,
depress
the button
for "crushed"
ice
and begin
dispensing
again.
Has the dispenser arm been held in too long? Ice will stop
dispensing when the arm is held in too long. Wait 3 minutes
for dispenser motor to reset before using again.
The water dispenser will not operate
properly
Freezer
door
closed
completely?
Close the door
firmly.
If it
does not close completely,
see "The doors
will not close
completely."
Refrigerator
connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator
to water
supply and turn water shutoff valve fully open.
Is the water pressure at least 30 psi (207 kPa)? The water
pressure to the home determines the flow from the dispenser.
See "Water
Supply Requirements."
Kink in the home water source line? Straighten the water
source line.
New installation? Flush and fill the water system.
Water
filter installed on the refrigerator?
The filter may be
clogged or incorrectly
installed.
Is a reverse osmosis water filtration
system connected to
your cold water supply? See "Water
Supply Requirements."
Water
is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
Glass not being held under the dispenser long enough? Hold
the glass under the dispenser for 2 to 3 seconds after
releasing the dispenser lever/pad.
New installation? Flush the water system. See "Prepare the
Water
System" or "Water
and Ice Dispensers."
Recently changed water filter? Flush the water system. See
"Prepare the Water
System" or "Water
and Ice Dispensers."
The dispenser water
is not cool enough (on some models)
NOTE: Water
from the dispenser is chilled to only 50°F (10°C).
New installation?
Allow 24 hours after installation
for the
water supply to cool completely.
Recently dispensed large amount of water? Allow 24 hours
for water supply to cool completely.
Water
not been recently dispensed? The first glass of water
may not be cool. Discard the first glass of water.
Refrigerator
connected
to a cold water
pipe? Make
sure the
refrigerator
is connected
to a cold water
pipe. See "Water
Supply
Requirements."
ACCESSORIES
Replacement
Parts:
To order stainless steel cleaner or replacement
filters, call
1-800-4-MY-HOME
® and ask for the appropriate
part number
listed below or contact your authorized
I<enmore dealer.
Stainless Steel Cleaner and Polish:
Order Part #D22 M40083
R
Water
Filter:
Order Part #9930
(P4RFWB)
Air Filter:
Order Part #W10335147A
Produce Preserver:
Order Part #W10335145A
WATER FILTER
CERTIFICATIONS
State of California
Department
of Public liealtb
Water
Treatment
Device
Certificate
Number
10-
2030
Date Issued: February 26, 2010
Cysts
Organic
('on|_t_illants
AtraTme
2.4-D
Rated
Service
Capacity:
200 gat
Rated
Service
Flow:
5 gpm
Conditions
of Certification:
Do no_ use where
water is microbiologically
unsafe
or with ,water of unknown
quality,
except that systems
cerlified
fbr cyst reduction
may be used on disinI"i:cted
waters
that Itaay colltain
filterable
cysts,
28

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido