Briteq BTX-TITAN SIRIUS HRI 280 Manual De Instrucciones página 14

ENGLISH
INFORMATION FIXTURE TIMES
Shows the operation time (in hours) since it first start.
INFORMATION LAMP TIMES
Lamp on times:
Lamp strikes:
Reset lamp time:
INFORMATION ERROR LIST
If an error is detected, a list of error(s) will appear here. By default, without any error: "no error".
INFORMATION DIAGNOSIS
Show the state of each cards. If one of the electronic card is not at 100%, contact the technical support.
INFORMATION FAN MONITOR
Shows the rotation speed of the fans. Speed in rotations per minute.
INFORMATION DMX VALUE
Shows the DMX value received by the Briteq BTX-TITAN on the DMX input. It can be used as a DMX
analyzer to check the values received.
PERSONALITY LAMP
Power on light (on – off):
 On: Turn the lamp on at power on.
 Off: The lamp has to be switched on using the local menu or DMX.
Lamp on by DMX (on – off):
 On: lamp can be switched on by DMX.
 Off: lamp cannot be switched on by DMX.
Lamp on delay (0-60min):
The lamp is automatically switched on 0-60min after the projector was switched on. Delayed start can be
useful in permanent installation.
PERSONALITY PAN TILT
Pan reverse (on-off)
 On: Pan works in opposite direction
 Off: Pan works normally
Tilt reverse (on-off)
 On: Tilt works in opposite direction
 Off: Tilt works normally
Feedback (on-off)
 On: pan/tilt position is automatically corrected.
 Off: pan/tilt position is not corrected.
PERSONALITY DMX INPUT
Used to set the desired input for the DMX signal:
 Wired Input: XLR (3 or 5pin) input is used.
 Wireless Input: DMX-signal comes from an external wireless transmitter (sold separately)
 Wireless Input / XLR out: DMX-signal comes from an external wireless transmitter (sold separately).
The wireless DMX-signal is also available at the DMX output port (3 or 5 pins) for further daisy chaining
of other equipment.
Important Remark: originally this projector is NOT equipped with a wireless receiver module. A wireless
receiver module is optionally available.
BRITEQ
®
Show the total hours with lamp on since it first start
Show the total count of lamp strike since it first start
Reset the total hours with lamp on since it first start.
Should be done after changing the bulb.
12/107
OPERATION MANUAL
BTX-TITAN