Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Remove the immersion blender from the pot/mixing vessel
after the blender has come to a complete stop. To prevent
splattering, do not remove the immersion blender from liquid
while it is on.
NOTE: Always remove the battery pack after each use. Keep
the appliance out of reach of children.
NOTE: If a piece of food becomes lodged in the protective blade
guard surrounding the metal blade, follow the safety instructions
below:
1. Release the power button.
2. Remove the battery pack from the housing.
3. Detach the shaft from the housing.
4. Use a spatula to carefully remove the food lodged in the
blade guard. CAUTION: The blade is very sharp. DO NOT
USE YOUR FINGERS TO REMOVE LODGED FOOD.
5. Reassemble unit and continue blending.
HELPFUL TIPS
• For best results, when a recipe calls for ice, use crushed ice and
not whole cubes.
• Unit will default to the same speed it was on when last in use.
• Depending on the speeds used and what you are blending, the
amount of time the charge will last may vary. For best results,
charge the battery pack regularly.
• Speeds:
Speed 1: Low speed, 5K RPM
Speed 2: 7K RPM
Speed 3: 8.5K RPM
Speed 4: 11.5K RPM
Speed 5: High speed, 13K RPM
TROUBLESHOOTING
This immersion blender is equipped with overload protection so
that it does not overheat and cause any permanent damage. During
operation, if you notice that the speed indicator lights on the front of
the housing are blinking, stop use, remove the battery and allow it to
cool down for approximately 90 seconds.
7
Publicidad
Tabla de contenido
