Safe Operation; Installation And Connection - Pontec Multi Clear Set 5000 Instrucciones De Uso

- EN -

Safe operation

 Never operate the unit if either the electrical cables or the housing are defective!
 Do not carry or pull the unit by its electrical cable.
 Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do not present a
tripping obstacle.
 Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
 Only execute work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
 Only use original spare parts and accessories for the unit.
 Never carry out technical modifications to the unit.
 The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
 Only operate the unit if no persons are in the water!
 The unit, the connections and plugs are not water-proof and must not be routed or installed in water.
 Keep the socket and power plug dry.
 Ensure that the filter will not overflow. Danger of emptying the pond.
Installation
The parts included in the scope of delivery are inside the container and have to be removed first!
How to proceed:
 B
1. Undo the fasteners on both sides of the container cover and lift off the container cover.
2. Take out the UVC clarifying unit. ( Cleaning the UVC clarifying unit)
3. Screw the stepped hose adapter including sealing ring onto the UVC inlet.
4. Screw the inlet elbow including sealing ring onto the UVC outlet.
5. Place the UVC water housing onto the container cover and fasten with both screws, washers and nuts.
– Insert the screws through the guides on the UVC water housing and the holes in the container cover.
6. Place the container cover onto the container and carefully press down until the fasteners engage.
7. Fit the UVC clarifying unit. ( Cleaning the UVC clarifying unit)

Installation and connection

 Do not expose the unit to direct sunlight.
– Maximum ambient temperature: 40 °C.
How to proceed:
 C
1. Place the filter container in a flood protected position on firm and level ground at least 2 m from the edge of the
pond.
– Ensure that the outlet is not more than 1 m above the surface of the pond.
– Ensure that the unit is easily accessible for maintenance and cleaning.
2. Connect the hose to the UVC clarifying unit (stepped hose adapter at the inlet) and to the filter pump (stepped hose
adapter at the outlet).
3. Connect e.g. an HT pipe (DN 50) or a 2" hose with a hose clip to the filter container outlet.
14