Honeywell CIRCUNDANTE HZ-2200 Manual Del Propietário página 3

12. To disconnect the heater, first turn controls to the OFF position, then grip
the plug and pull it from the wall outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surface, like a bed, where openings may
become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in the
areas where gasoline, paint, or flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
17. The output of this heater may vary and its temperature may become intense
enough to burn exposed skin. Use of this heater is not recommended for
persons with reduced sensitivity to heat or an inability to react to avoid burns.
SAVE THESE INSTRUCTIONS
18.
SET UP
• Place the heater on a firm, level, open surface free
from obstructions and at least 3 feet (0.9m) away
from any wall or any combustible material. DO NOT
use on an unstable surface such as bedding or deep
carpeting. BE SURE THE HEATER IS NOT IN A
POSITION WHERE IT MAY BE TRIPPED OVER
BY SMALL CHILDREN OR PETS.
• The Surround Heat™ Heater is designed to
disperse heat in either a 360° range or in one direction only.
• To select the desired heating mode, slide the Direction Control switch, located
on the top of the heater, to the position of your choice (Fig. 1):
– to the right (full circle) for 360° Heating
– to the left (half circle) for forward only heating (One Direction
Heating)
Fig. 1
One Direction 360º Heating
Heating
(Forward Only)