How To Install; How To Use - Gardigo 60048 Instrucciones De Uso

ANIMAL CHASER PRO
Manual
Art.-Nr. 60049
Congratulations on your purchase of the Animal Chaser Pro.
Please read these operating instructions thoroughly before
use. It is important for proper use of the product.
1. General
The Animal Chaser Pro provides a convenient, effective and
humane way to deter cats, dogs, and even raccoons from
your garden, yard and lawn without harm. This product utili-
zes a sophisticated PIR (passive infrared) detection system
to monitor a large area up by up to an approximate distance
of 23 ft. When an animal enters the area covered by the
infrared sensor, the Animal Chaser Pro produces an ultra-
sonic sound at a frequency range from 18 kHz up to 60 kHz
that is very unpleasant to animals but virtually inaudible to
the human ear. In addition to the noise the unit emits, the
Animal Chaser Pro also emits an intense LED strobe light to
further ward off unwanted animals.
a. Speaker
b. LED strobe light
c. Passive Infre-red
motion detector (PIR)
d. Switch
e. Battery Compartment
WARNING:
· Turn off the Animal Chaser Pro if
your pet is playing in the protec-
ted area!
· Do not immerse the unit in water or any other liquid!
· Do not modify or tamper the unit or its internal compo-
nents. Covering or painting over the front speaker grill
can damage the unit and cause it to malfunction.
· For best function, keep the PIR lens clear. Use a damp
cloth to wipe them. Do not use benzene, alcohol or
paint thinner!
· Do not mount where it can fall and injure others!
Note: For outdoor use only. Your pets may not be deter-
red by this product as they see your home as their home
and territory.
a
b
c
d
ON1 OFF ON2
e
2. Battery Installa-
tion
1. Remove two screws on the
bottom of unit to access
battery compartment
2. Insert 5 x "AA" alkaline or
lithium batteries. Be sure to follow the polarity diagram
and insert the batteries correctly. Do not mix old and
new batteries.

3. How to install

With Mounting Plate
1. Determine the location you want to place
your Animal Chaser Pro. Mounting loca-
tions are preferably at 5 to 8 ft in height,
in view of the protected area, out of reach
of children and placed where it can not fall
and injure others.
2. Using a pencil, mark the center of where you would like
the screw to be placed and have a drill bit a little smaller
than the closed end of the plastic anchor ready.
3. Using the drill bit, drill a hole through the center of
your mark and about as deep as the an chor is long.
4. Using a hammer or rubber mallet, gently tap the
anchor until it is flush with the wall.
5. Insert the screw and slowly rotate it into the anchor
leaving about 1/8 or 1/4 of the screw out to hang the
Solar Animal Chaser.
Note: Anchors are most notably used on drywall and
plaster, for most other walls it is not needed.
With Stand
1. Connect all pieces of stand together.
2. Unscrew the mounting plate from de-
vice.
3. Replace the mounting plate to the
stand.
4. Determine the location you want to place your Animal
Chaser Pro with stand.

4. How to use

The Animal Chaser Pro has a three position switch which
is located on the bottom of the unit housing.
1. ON1 –
When the motion sensor is triggered, the unit
will produce a high pitched ultrasonic frequency in