Hitachi H 60KA Instrucciones De Manejo página 5

English
PRECAUTIONS ON USING DEMOLITION
HAMMER
1. Wear earplugs to protect your ears during
operation.
2. Do not touch the tool during or immediately after
operation. The tool becomes very hot during
operation and could cause serious burns.
SPECIFICATIONS
Voltage (by areas)*
Power Input
Full-load Impact Rate
Weight (without cord, side handle)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case ............................................................................ 1
(2) Bull Point .................................................................... 1
(3) Side Handle ................................................................ 1
(4) Hexagon Bar Wrench (for 8mm screw) ................. 1
(5) Dust cover .................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Demolitioning
(1) Bull Point
Overall Length: 300, 380, 450 mm
Asphalt Cutting
(1) Cutter
Overall Length: 400 mm
Width: 50, 75 mm
Groove digging and edging
(1) Cold chisel
Overall Length: 300, 380, 450 mm
Hammer Grease A
500g (in a can)
70g (in a tube)
30g (in a tube)
Optional accessories are subject to change without
notice.
4
3. Before starting demolishing work or chiseling onto
a wall or floor, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
(110V, 230V, 240V)
1300W*
1600/min.
11.0 kg
APPLICATIONS
Demolishing concrete, chiseling concrete, grooving, bar
cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility
installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other
civil engineering work.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. How to install dust cover (Fig. 1)
Allways install the dust cover on the tool.
Insert the dust cover until it lies flush in the groove.
5. Installing Tools
CAUTION
To prevent accidents, make sure to turn the switch
off and disconnect the plug from the receptacle.
NOTE:
When using tools such as bull points, cutters, etc.,
make sure to use the genuine parts designated by
our company.
(1) Clean, then smear the tool shank with the grease
provided.
(2) Slide the stop lever in the direction of arrow A and
rotate it 180°.
Turn the notch of the tool shank downward and
insert it fully into the hexagonal hole of the front
cover. (Fig. 1)