Descargar Imprimir esta página

Yakima LANDING PAD 11 Manual De Instrucciones página 2

Ocultar thumbs Ver también para LANDING PAD 11:

Publicidad

Idiomas disponibles

Idiomas disponibles

1
IF YOUR VEHICLE
HAS FACTORY
CROSSBARS, REMOVE
THEM NOW, THEN
PROCEED TO STEP 3.
3
DETERMINE YOUR HARDWARE
AND PREPARE THREADS.
Refer to the fit chart on page 5 (or online at
yakimatech.com if your vehicle is not listed) to
determine the correct hardware for your vehicle.
Be sure the
threads are
clear of paint by
carefully threading
your fastener in
and out of the hole
a few times while
blowing away
any debris that
accumulates.
NOTE: If there are multiple
holes in each pocket, use
the rear-most holes.
INSTRUCTION #1033512N - PAGE 2 of 36
2
OPEN THE COVER-PLATES.
NOTE: Some vehicles
have a plug in the threads
which must be removed.
4
REMOVE THE COVERS.
Remove the covers
from the bases.
When the racks are not
installed, use the covers to
keep the bases free of debris.
Consult your vehicle's owner's
manual to determine how your
cover plates are opened or removed.
This will vary from vehicle to vehicle.
5
INSTALL PADS
TO BASES.
Attach each pad
to each base.

Publicidad

loading