Sears Kenmore Pro 79079523600 Manual De Instrucciones página 5

Direct EJectrical Connection to the Circuit
Breaker, Fuse Box or Junction Box
If the appliance is connected directly to the circuit breaker,
fuse box or junction box, use flexible, armored or non
metallic sheathed copper cable (with grounding wire).
Supply a U.L listed strain-relief at each end of the cable. At
the appliance end, the cable goes through the Direct
Connection Hole (see Figure 4) on the Cord Mounting
Plate. Wire sizes (copper wire only) and connections must
conform to the rating of the appliance.
You may not ground the oven
through the neutral (white) wire if oven is used in
a new branch circuit instaJlation (1996 NEC), mobiJe
home, recreational vehicle, or where local codes do
not permit grounding through the neutral (white)
wire. When grounding through the neutral (white)
wire is prohibited, you must use a 4-wire power
supply cable. See Figure 6. Failure to heed this
warning may resuJt in eJectrocution or other
serious personaJ injury.
Where local codes permit connecting the appJiance
cable ground wire to the power suppJy cable
neutral (white) wire (see Figure 5).
I. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box:
Connect appliance and power supply cable wires as
shown in figure 5.
Cable from Power Supply
White Wire
(Neutral)
RedWires
Wires
1
Box
White Wire
(Neutral)
Ground Wire U.L-Listed
(Bare or Green Wire) Conduit Connector
(or CSA listed)
Cable from appliance
Figure 5
3-WIRE GROUNDED JUNCTION BOX
improper connection of aluminum
house wiring to copper leads can result in a short
circuit or fire. Use onJy connectors designed for
joining copper to aluminum, and follow the
manufacturer's recommended procedure closely.
if oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle, or
where local codes DO NOT permit connecting the
appliance cabJe ground wire to the power supply
cable neutral (white) wire you must use a 4 wire
power supply cable (see figure 6):
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box:
Connect appliance and power supply cable wires as
shown in figure 6.
Ground
Wire
Cable from Power Supply
White Wire
Ground Wire
(Bare or
Green Wire)
_White Wire
Junction Box U.L-Listed
Conduit Connector
(or CSA listed)
Cable from appliance
Figure 6
4-WIRE GROUNDED JUNCTION BOX
DO NOT ground to a gas supply pipe. DO NOT connect
to electrical power supply until appliance is permanently
grounded. Connect the ground wire before turning on
the power (Figure 6).
NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature rating of household wiring. The
current carrying capacity of the conductor is governed by
the temperature rating of the insulation around the wire,
rather than the wire gauge alone.