Idexx SNAP Pro Analyzer Guia De Inicio Rapido página 6

Running a SNAP test
With an IDEXX VetLab* Station
1. Tap Analyze Sample on the IDEXX VetLab Station
Home screen to enter the patient information and
start a run.
OR
If the IDEXX VetLab Station is integrated with a
practice management system, proceed to step 2 or
select the patient from the Pending or Census list on
the IDEXX VetLab Station Home screen.
Note: All patients that appear in the Pending list on
the IDEXX VetLab Station also appear on the
SNAP Pro* Home screen.
OR
Tap New Patient on the SNAP Pro Home screen to
enter the patient's name and client ID. When you have
finished entering the information, tap the Check
Mark
icon and proceed to step 3.
2. Once the patient's name appears in the list on the
SNAP Pro Home screen, tap the patient's name and
then tap the Check Mark icon.
3. Prepare the SNAP* test, but
do not activate the test.
4. Gently slide the SNAP test into
the port at the bottom of the
analyzer (well end first) until it
clicks into position.
When analysis is complete,
results are shown on the results
screen and are sent to the
IDEXX VetLab Station
automatically.
Tip: The color of the
status light indicates the
results of the run:
Green—all results are
negative
Blue—at least one
result is positive
Yellow—visual
confirmation
needed (use the
instructions on the
next page)